Primary chaincase seal Material: neoprene cord. For Commando 1968 to 1974 (Replaces part 06.0398)

out of stock

MAGNETIC SUMP & DRAIN PLUG SET with WASHERS for ENGINE/GEARBOX/OIL TANK (Dommie, Atlas, 650ss and Mercury)

in stock

DRAIN PLUG OIL TANK DOMMIE/ATLAS (WITH MAGNET)

in stock

Dominator Chaincase sealing band - neoprene

in stock

CRANKCASE BREATHER CONVERSION KIT (for 1971/1972 COMMANDO with removeable plate at back of timing cover)

in stock

LUCAS 12V LED Wedge (Capless) Instrument Bulb

in stock

BULB HOLDER & LEAD ASSY including LED BULB (Two required)

in stock

LUCAS LED BA9S Pilot/Instrument bulb 12V

in stock

HEADLAMP UNIT 7" H4 R/H DIP complete with TWO LED BULBS WIPAC MAIN & PILOT for countries riding on right hand side of the road

in stock

HEADLAMP UNIT 7" H4 L/H DIP WITH TWO LED BULBS WIPAC MAIN & PILOT (54526114) for UK & countries riding on left hand side of the road.

in stock

LED bulb set Norton Commando 850MK3 1975 to 1978

in stock

Charge warning light (BSM - Battery Status Monitor) extended lead version - 2 metres - Fits all 12V DC pos & neg earth

out of stock

Distributor body/Magneto Replacement. Replaces the K1F/K2F and KVF type magnetos. Suitable for fitting electronic ignition to pre-unit models.

in stock

LUCAS LED BA7S Instrument/Warning Light Bulbs 12V

in stock

LED bulb set Norton Commando pre 850MK3 1973 to 1974 (suitable for rectangular type Lucas 917 rear lamp unit)

in stock

LED bulb set Norton Commando 1968 to 1972 fitted with indicators (suitable for rounded type Lucas 679 rear light unit)

in stock

Charge warning light (BSM - battery status monitor) Suitable for all 12V DC vehicles positive or negative earth with a charging system

in stock

LUCAS LED Flasher Relay 12v suitable for led turn signal bulbs. For use on Positive or Negative systems

in stock

LUCAS LED Indicator turn signal bulb12V/21W For use on Positive or Negative systems

in stock

LUCAS LED Stop/Tail Bulb 12V BAY15D fitting suitable for Lucas 917 rear light. For use on Positive or Negative systems.

in stock

Electronic Ignition kit Tri Spark: Regulator/Rectifier complete with capacitor and one 12v dual output ignition coils. Includes mounting bracket.

out of stock

LUCAS LED Headlight Bulb H4 fitting 6-24V. For use on Positive or Negative systems.

in stock

Electronic Ignition kit Tri Spark: Regulator/Rectifier complete with capacitor and two 6v ignition coils. Includes mounting bracket.

out of stock

IGNITION COIL 12V Tri Spark (IGC-2012) DUAL OUTPUT

in stock

INDICATOR KIT Lucas (4 LONG STEM) FOR 1971 and 1972 COMMANDO with Lucas cast switchgear. With instructions

in stock

LUCAS LED Stop/Tail Bulb 12V BAY15D fitting suitable for Lucas 564, 529 and 679 rear lights.For use on Positive or Negative systems.

in stock

Clutch plain plate for Commando 750/850 (3mm thick hardened and ground) *Replaces one 2mm thick plate to achieve a lighter clutch lever action*

in stock

Clutch STUFFER plate for Triumph 500/650/750 twins Barnett USA (0.115" thick) Adds an extra half plate to the clutch. Replaces one plain drive plate

in stock

Amal Concentric Premier Carburettor Pack (2 carbs) for Norton Commando 850cc Mk2a 1974 32mm Main jet 260 Throttle valve No.3.1/2 Needle jet 0.106 Pilot jet 19 (PACK 138) includes single inlet fuel pipe banjos and filters

in stock

FRONT BRAKE IMPROVEMENT KIT CP2696 (AP RACING /LOCKHEED) CALIPER LEADING c/w RIGHT SIDE SLIDER

out of stock

FRONT MASTER CYLINDER ASSEMBLY complete and ready to fit with LEVER 850mk3 (13mm bore) PAINTED GLOSS BLACK

in stock

MAGNETIC DRAIN PLUG SET including WASHERS FOR SUMP, OIL TANK & GEARBOX (COMMANDO 750/850 from 1972 to 1978)

in stock

ALTON DYNAMO FOR NORTON MOTORCYCLES UP TO 1957 Suitable for Dominator, 7, 88 and 99 originally fitted with 3 inch dynamos

in stock

ALTON MAGDYNO MOTORCYCLES UP TO 1958

in stock

STAY UP FLOAT KIT

in stock

RECTIFIER/REGULATOR (SINGLE & 3 PHASE) WITH CAPACITOR 20AMP TRI SPARK MOSFET VR-0030 - This part replaces the rectifier, zener diode and capacitor.

in stock

INDICATOR KIT Lucas (2 SHORT & 2 LONG STEM) FOR 1971 and 1972 COMMANDO with Lucas cast switchgear. With instructions

in stock

OIL FILTER KIT (WITH PLAIN 1/2" ID HOSE) BARBED PIPES

in stock

MOUNTING KIT for PODTRONICS & TRI SPARK RECTIFIER suitable for COMMANDO silver zinc plared finish

in stock

HEADLAMP UNIT 7" H4 R/H DIP complete with BULBS WIPAC for countries riding on right hand side of the road

in stock

HEADLAMP UNIT 7" H4 L/H DIP WITH BULBS WIPAC (54526114) for UK & countries riding on left hand side of the road.

in stock

BULBHOLDER for H4 bulb

in stock

ISOLASTIC KIT FRONT VERNIER for COMMANDO 750 850 1968 to 1974 *YOUR FRONT ENGINE MOUNT MUST BE UNMODIFIED - CALL IF NOT SURE *

in stock

Amal Concentric Premier Carburettor Pack (2 carbs) for Norton Commando 850cc Mk2a & Mk3 1974-1975 32mm Main jet 220 Throttle valve No.3.1/2 Needle jet 0.106 Pilot jet 19 (PACK 113) includes double inlet fuel pipe banjos and filters

in stock

Amal Concentric Premier Carburettor Pack (2 carbs) for Norton Commando 850cc Mk1 Mk2 1973-1974 32mm Main jet 260 Throttle valve No.3.1/2 Needle jet 0.106 Pilot jet 19 (PACK 136) includes single inlet fuel pipe banjos and filters

in stock

Amal Concentric Premier Carburettor Pack (2 carbs) for Norton Commando 750cc 1968-1972 30mm Main jet 220 Throttle valve No.3 Needle jet 0.106 Pilot jet 17 (PACK 111) includes single inlet fuel pipe banjos and filters

in stock

TACHO DRIVE HOUSING WITH OIL SEAL (06.1090 & 06.5200)

in stock

ISOLASTIC KIT REAR VERNIER (for all 750/850 COMMANDOS)

in stock

ISOLASTIC KIT FRONT VERNIER MK3 ONLY (use 06.7337 Pre Mk3)

in stock

CLUTCH CABLE outer cable length:46" (EUROPE MK3) Featherlight

in stock

CLUTCH CABLE outer cable length:48" (EUROPE Pre MK3) Featherlight

in stock

TWIN LEADING SHOE (TLS) 8 inch FRONT BRAKE PLATE ASSY including SHOES & STIFFENING KIT FOR 8 INCH HUB

in stock

TWIN LEADING SHOE (TLS) 8 inch FRONT BRAKE PLATE ASSEMBLY complete with FIXED FITTINGS

in stock

CLUTCH CABLE outer cable length:51" (WESTERN BARS) (06.2492) (06.6477)(06.0919) Featherlight

in stock

GEARBOX OUTER COVER ASSY

out of stock

MAGNETIC CRANKCASE (SUMP) FILTER KIT Suitable for all Norton 500-850 twins (except some1972/3 models)

in stock

REAR BRAKE LEVER SAFETY SPRING FOR 1968 to 1974 Commando. Prevents brake lever dropping if rear brake cable breaks.

in stock

OIL FILTER KIT (WITH PLAIN 3/8" ID HOSE) BARBED PIPES

in stock

FRONT DRUM BRAKE STIFFENING KIT for 8 inch twin leading shoe brake

in stock

Electronic Ignition kit Pazon Surefire (12v) for Norton, Triumph & BSA. This system replaces the points, ballast resistor, condensers and mechanical advance unit.

in stock

Electronic Ignition kit Tri Spark TRI - 0006 suitable for 750 850 Commando 1968 to 1977, late Atlas. 1968 P11 Ranger and Triumph Unit Twins: T100, T120, TR7RV, and T140 Bonneville

in stock

RECTIFIER/REGULATOR (SINGLE-PHASE) with capacitor PODTRONICS 200w This part replaces the rectifier, zener diode and capacitor.

in stock

RECTIFIER/REGULATOR (3-PHASE) with capacitor PODTRONICS This part replaces the rectifier, zener diode and capacitor.

in stock

CAMSHAFT PW3 (DOMMIE/ATLAS/EARLY COMMANDO) WITH LUBE PACK Material: Steel 655M13 (EN36B) Made in England

in stock

CAMSHAFT PW3 COMMANDO (REV COUNTER DRIVE) WITH LUBE PACK Material: Steel 655M13 (EN36B) Made in England

in stock

FRONT MASTER CYLINDER ASSY complete and ready to fit with LEVER (Pre850MK3) (13mm bore)

in stock

FRONT MASTER CYLINDER ASSEMBLY complete & ready to fit with LEVER 850mk3 (13mm bore) PAINTED SATIN BLACK

in stock